Лего зеленый гоблин инструкция

Hi everyone! This is my first instructable and I hope this will help your LEGO building ideas.

This is how to make a Green Goblin Glider from the Spiderman comics, loosely based on the one in the LEGO Marvel Superheroes video game, but with a few changes.

These are parts needed to build the glider:

— 1 1×1 round cylinder brick, grey

— 3 1×2 plates, grey

— 1 2×4 plate, grey

— 1 small flame, trans-orange

— 2 flags, grey

— 1 1×2 attic, grey (that’s what it was called on brickset)

— 1 2×4 wheel arch, grey

— 1 1×2 jumper plate, grey

— 2 1×2 plate with handle, grey

— 2 1×2 plate with clips, grey

— 2 1×2 angular plate with studs

— 2 1×2 plate with handle 3.18, grey

— 2 2×2 plate with 1 technic hole, grey

— 4 1×2 lattice/grill slope, grey

It doesn’t matter what shades of grey you use (I had a mixture of dark/light), unless you want to make a custom one.

To make the body of the glider, you need to:

1. Put the 2 angular plates with studs and place them on the 2×4 plate on each end

2.Take the 2 1×2 plates with handle (3.18) and put them in the middle of the 2×4 plate

3. Attach the wheel arch onto the very front of the body

4. Take the 3 1×2 plates and put two of them together with one sideways on top

5. Place it on the back of the glider as shown in the picture (with the one on top at the end)

6. Attach the jumper plate onto the back angular brick (on the side studs — not on top)

7. Put the flame piece into the round cylinder brick and then put it onto the jumper plate

1. Attach the 1×2 plate with clips on the left side of the 2×2 plate with 1 technic hole (with the hole facing you) and the 1×2 plate with handle on the right side.

2. Put the flag piece onto the 1×2 plate with handle — make sure it is facing the same way as in the picture —

3. Place 2 of the lattice/grill slopes sideways on the wing. Make sure they have the end of the slope near the flag piece.

4. Attach the wing onto the 1×2 plate with handle (3.18) on the main body as in the picture

1. Attach the 1×2 plate with clips on the right side of the 2×2 plate with 1 technic hole (with the hole facing you) and the 1×2 plate with handle on the left side.

2. Put the flag piece onto the 1×2 plate with handle — make sure it is facing the same way as in the picture —

3. Place 2 of the lattice/grill slopes sideways on the wing. Make sure they have the end of the slope near the flag piece.

4. Attach the wing onto the 1×2 plate with handle (3.18) on the main body as in the picture